 |
|
 |
Vorheriges Thema anzeigen :: Nächstes Thema anzeigen
|
Autor
|
Nachricht
|
MichaelSmith
Grade reingestolpert

Anmeldungsdatum: 11.06.2018
Beiträge: 1
|
Verfasst am: 12.06.2018 - 08:46 Titel: SAM3S-EK2 Atmel ICE Programming Issue |
|
|
Hi,
I recently received a SAM3S-EK2 evaluation kit and I have not been able to successfully program it with the Atmel ICE debugger. I am using the Atmel ICE adapter to connect to the ARM JTAG port on the baseboard. In addition I am setting JP3 to erase the flash and clear the GPNVM bits. After doing this I am able to erase the flash, but I am unable to program. Programming always fails on the verifying step and outputs the following message:I have been able to program the board using SAM-BA and then I can go into Atmel Studio 6.2 and debug the program. This is absolutely maddening though. I hope someone can tell me that I am doing it wrong. I have been through all the documentation and cannot get the programming over JTAG to work.
Please help.
I did not find the right solution from the internet.
References:
http://www.at91.com/viewtopic.php?t=22711
Animated video quote
Thanks!
|
|
Nach oben
PDF
|
|
|
|
Alle Zeiten sind GMT - 11 Stunden
|
|
Du kannst keine Beiträge in dieses Forum schreiben. Du kannst auf Beiträge in diesem Forum nicht antworten. Du kannst deine Beiträge in diesem Forum nicht bearbeiten. Du kannst deine Beiträge in diesem Forum nicht löschen. Du kannst an Umfragen in diesem Forum nicht mitmachen.
|
|
|